![]() name server(your pc ips) gateway the same ip as sever. ![]() and enter the ips you got from the first step double check DCC AFTER YOU CHANGE IPS to make sure your communication settings are correct! very important or you wont go any further!! the first ip is the receivers IP, netmask is the same as you got from pc. ![]() Here you're going to load your image using dreamup universal, double click on dreamup and a window will open then click connect and wait for the message box is alive and speaking to us, click on flash and select the image wanted(dsmremaster beta2.) double click on it if you're prompted OK press OK or just press install then wait for about 5 to 9 minutes to load image.ģ-connect receiver to tv. If your receiver has a rolling screen is because is setup using pal image(Europe) to stop it just press right arrow on remote until you see it stop (NTSC) save and exit.Ģ-make sure receiver is unplugged. Is going to ask if you're sure you want to load press yes and wait about 5 min.after completed reboot receiver and watch tv!!!!! remember that my flash is going to install the ips iam using on my setup so once you get my flash on your box you have to re enter the ips you had before you uploaded my flash or you wont be able to send anything else to the box. for windows xp go to start / run and type cmd and a black window is going to open where the line is blinking type ipconfig/all and press enter this is gonna bring all ips write them down you're goin to need them (ip address for your pc) (net mask for dreambox)(default gate way for router) you have to verify the communication is set correctly go to tv, menu, scroll to the right and find the wrench or 2 gears press OK go down to expert press OK select communication setup, press OK change the netmask to values you got from pc (the one you wrote down) and enter it exactly how it was, go down to name server and type your ip address(the one you got from pc) then go to gateway and type the same as name server make sure you have port 80 on the lower window on the upper bottom DHCP remove check mark, check enable network press green button to save and exit to main screen turn off receiver and unplug wait and plug it back in after all this go back to using dreambox control center program open it with the box connected through cad5 cable only, under the dreambox option right below dreambox picture"search" press it and is going to give you some ips for the box only, pick one double click on it to put it under dreambox window, write it down and go back to receiver press menu scroll to right find wrench or gears /OK /expert setup/communication setup/and enter the ip you save from under dreambox window "at dreambox control center" the one you just added under dreambox ip (last one you wrote down) and enter it on the very first option at the top "IP" press green button save /exit to main menu unplug and plug back in ,close dream control center and reopen it and check for the green lines if there all green it means you are connected however you're not using this program for the flash it was just to check communication, now you need to open flash wizard program and load the image (wanted image followed by emu you want), press install a firmware is the first option on top, click drag & drop and find the file (or any working image fro dmb ) you need to do this using a cad 5 cable (looks like a phone cable) ![]() The first step is to find your ips for pc and box. Also once you have the rqcam on give it a few minutes on a N2 channel to build up the EMU.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |